Figure 11: Installing Top Plate In Housing - Honeywell HD6 Series Installation Manual

3.2 WIRING – STANDARD, CONTINUED
INSTRUCTIONS FOR INSTALLING TOP PLATE IN HOUSING
1. Align the tabs on the top plate with the slots in the top hat. Make sure the tabs
are inserted into the holes and the tips of the tabs are on the outside of the top
hat. See Detail A.
2. Push the plate up into the top hat until the spring latch is secured in the notch on
the side of the top hat. See Detail B.

Figure 11: Installing Top Plate in Housing

9. Refer to the HD6 Series User Manual to install the scan.
Rev. 1.02
SEE DETAIL A
SEE DETAIL B
WARNING: Make sure that the top plate is secured in the housing
by gently pulling on the white connector. If the plate comes down
when you gently pull on the connector, the plate is not secured
properly.
DETAIL A
ALIGNMENT TAB
SHOWN ON OUTSIDE
OF HOUSING
DETAIL B
LATCH SHOWN
INSERTEDIN NOTCH
ON SIDE OF HOUSING
26 900.0696
1-Aug-06