Figure 6: Mounting Bracket Hole Detail - Honeywell HD6 Series Installation Manual

2.4 HD6 RUGGED DOME HOUSING , CONTINUED
7. Mount the housing to a ceiling support structure or wall support structure.
The installer supplies the mounting hardware. There are four sets of mounting
holes.
3.500
2.625

Figure 6: Mounting Bracket Hole Detail

a. The mounting bracket can be positioned between 0°-45° or 45°-90° depending
b. The mounting bracket can be repositioned by loosening the four nuts (two on
c. Secure the mount to the wall or ceiling using the appropriate hardware for the
NOTE: The mounting bracket can be at any angle from 0° to 90° with respect to the
housing.
Rev. 1.02
.313
TYP.
.437
TYP.
on the orientation of the mounting bracket on the housing. To change the
orientation of the bracket, remove the four nuts, lock washers and bolts that
secure the bracket to the housing. Flip the bracket over and secure the bracket
to the housing using the four nuts, lock washers, and bolts.
each side) inside the housing and sliding the bracket along the slot. Tighten the
four nuts to secure the bracket at the desired angle.
mounting surface.
The housing must be positioned horizontal and parallel with the floor.
3.500
2.625
6. 500
12
1.930
.300
TYP.
1.150
1.000
1.150
900.0696
1-Aug-06