Figure 9: Safety Cable Installation - Honeywell HD6 Series Installation Manual

2.5 WEATHER DOME HOUSING , CONTINUED
SAFETY CABLE INSTALLATION
(SUPPLIED BY INSTALLER)
ATTACH THE SAFETY CABLE
TO A BUILDING SUPPORT STRUCTURE
SPLICING SLEEVE
SAFETY CABLE
SPLICING SLEEVE
LOOP AROUND PIN IN BLACK
NIPPLE OF WEATHER DOME

Figure 9: Safety Cable Installation

7. Install the weather dome on the mount. Carefully push the cabling from the weather
dome up into the mount and thread the weather dome into the threaded pipe on the
mount.
8. After the weather dome is threaded into the mount as far as it will go, thread the
conduit nut on the weather dome up against the mount and tighten. Seal the joint
between the mount and the black nipple on the weather dome with Dow RTV 3145.
9. Connect mating connector J2 (field wiring) in the mount to connector P2 on the
weather dome (on 14-pin connector version only.)
10. Replace the cover on the mount conduit box or access hole cover plate on the
MDW1210W mount using the two screws removed when installing the mount.
Rev. 1.02
CAUTION: Do not force the dome into the threaded pipe.
The nipple on the weather dome is plastic and the threads on the
nipple could be stripped if force is used.
CAUTION: Ensure all field wiring is pushed back into the mount
pipe. Ensure the gasket between the conduit box or mount and
the cover is seated properly.
16 900.0696
1-Aug-06