Cisco 2800 Series Manual page 84

Configure
ds0-group 4 timeslots 4 type e&m-immediate-start
ds0-group 5 timeslots 5 type e&m-immediate-start
ds0-group 6 timeslots 6 type e&m-immediate-start
!
no crypto isakmp enable
!
!
!---Loopback0 used to bind H323 to the Loopback0 interface. RTP Packets
!---originate/terminate on the router using this IP address.
!
interface Loopback0
ip address 10.1.152.9 255.255.255.255
h323-gateway voip interface
h323-gateway voip bind srcaddr 10.1.152.9
!
interface Loopback2
ip address 10.1.152.241 255.255.255.252
ip ospf network point-to-point
!
interface Loopback3
ip address 10.1.152.249 255.255.255.252
ip virtual-reassembly
ip ospf network point-to-point
!
!---Configuration to enable Hoot and Holler using multicast on router. The multicast
!---streaming of packets from the local router uses the VIF interface to derive the local
!---ip address and the port of the packets. This can be verified by the show command "show
!---voip rtp connection"
!
interface Vif1
ip address 10.1.153.41 255.255.255.252
ip pim sparse-dense-mode
!
!
!---WAN uplink
!
interface Serial0/0/0
ip address 10.1.152.30 255.255.255.252
ip pim sparse-dense-mode
ip nat outside
ip virtual-reassembly
no fair-queue
!
!--- Content Engine connected as a Network Module.
!
interface Content-Engine1/0
ip unnumbered Loopback3
ip pim sparse-dense-mode
service-module ip address 10.1.152.250 255.255.255.252
service-module ip default-gateway 10.1.152.249
!
!
interface FastEthernet3/0
switchport access vlan 110
switchport trunk native vlan 100
switchport mode trunk
switchport voice vlan 110
no ip address
!
interface FastEthernet3/1
switchport access vlan 100
switchport trunk native vlan 100
switchport mode trunk
OL-6574-01
8
IP Communication Solution for Group Applications Configuration Example