Cisco 2800 Series Manual page 153

Hoot and Holler over V3PN Configuration Example
interface Vlan1
no ip address
!
router ospf 1
log-adjacency-changes
network 192.168.2.0 0.0.0.255 area 0
network 192.168.7.0 0.0.0.255 area 0
!
ip classless
ip route 0.0.0.0 0.0.0.0 10.32.153.33
ip route 192.168.1.0 255.255.255.0 Null0 249
!
ip http server
no ip http secure-server
!
! SPECIFY TRAFFIC TO BE ENCRYPTED (HERE IT'S ALL GRE TRAFFIC)
!
ip access-list extended IPSEC_ACL_1
permit gre host 10.32.153.34 host 10.32.152.26
!
!
!
control-plane
!
!
!
! CONFIGURE THE VOICE PORT AND LINK IT TO DIAL-PEER 100. THIS CONNECTION IS PERMANENT. THE
VOICE-CLASS WAS DEFINED EARLIER IN
! THE CONFIGURATION, AND ESTABLISHES AN 'ALWAYS ON' CONNECTION
!
voice-port 1/0
voice-class permanent 1
timeouts call-disconnect 3
connection trunk 100
!
voice-port 1/1
!
voice-port 1/2
!
voice-port 1/3
!
!
!THIS DIAL-PEER CONNECTS THE VOICE PORT TO MULTICAST GROUP 239.168.1.100. g711 CODEC (64k)
IS USED, AND VAD IS ENABLED
!
dial-peer voice 100 voip
destination-pattern 100
session protocol multicast
session target ipv4:239.168.1.100:19890
codec g711ulaw
vad aggressive
!
!
!
line con 0
line aux 0
line vty 0 4
login authentication USERLIST
!
end
Configure
OL-6573-01
13