Information About The Setup Command Facility; Using The Setup Command Facility To Perform Basic Configuration - Cisco 2800 Series Manual

Information About the Setup Command Facility

Information About the Setup Command Facility
The setup command facility prompts you to enter the information that is needed to configure a router
quickly. The facility steps you through a basic configuration, including LAN and WAN interfaces. For
more general information about the setup command facility, see the following document:
Cisco IOS Configuration Fundamentals Configuration Guide, Release 12.2:
Part 1: Cisco IOS User Interfaces:
Using AutoInstall and Setup
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/ffun_c/ffcprt1/fcf002.htm
Using the Setup Command Facility to Perform Basic
Configuration
This section shows how to configure a hostname for the router, set passwords, and configure an interface
for communication with the management network.
The messages that will be displayed will vary, depending on your router model, the installed interface
Note
modules, and the software image. The following example and the user entries (in
examples only.
If you make a mistake while using the setup command facility, you can exit and run the setup command
Note
facility again. Press Ctrl-C, and enter the setup command in privileged EXEC mode (Router#).
Enter the setup command facility by using one of the following methods:
Step 1
•
•
Step 2 To proceed using the setup command facility, enter yes.
Basic Software Configuration Using the Setup Command Facility
2
From the Cisco IOS CLI, enter the setup command in privileged EXEC mode:
Router> enable
Password: <password>
Router# setup
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]:
If your router reloads and does not already have a configuration file, you are prompted to enter the
setup command facility:
Would you like to enter the initial configuration dialog? [yes/no]:
) are shown as
bold
OL-5992-01