Cisco 2800 Series Manual page 261

Upgrading the System Image
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
copy nvram:startup-config {ftp: | rcp: | tftp:}
Example:
Router# copy nvram:startup-config ftp:
Step 3
dir flash:
Example:
Router# dir flash:
Step 4
copy flash: {ftp: | rcp: | tftp:}
Example:
Router# copy flash: ftp:
Examples
Copying the Startup Configuration to a TFTP Server: Example
The following example shows the startup configuration being copied to a TFTP server:
Router# copy nvram:startup-config tftp:
Remote host[]? 172.16.101.101
Name of configuration file to write [rtr2-confg]? <cr>
Write file rtr2-confg on host 172.16.101.101?[confirm] <cr>
![OK]
Copying from Flash Memory to a TFTP Server: Example
The following example uses the dir flash: privileged EXEC command to obtain the name of the system
image file and the copy flash: tftp: privileged EXEC command to copy the system image
(c2800-2is-mz) to a TFTP server. The router uses the default username and password.
Router# dir flash:
System flash directory:
File Length Name/status
1 4137888 c2800-image-mz
[4137952 bytes used, 12639264 available, 16777216 total]
16384K bytes of processor board System flash (Read/Write)\
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Copies the startup configuration file to a server.
• The configuration file copy serves as a backup copy.
• Enter the destination URL when prompted.
Displays the layout and contents of a flash memory file
system.
Write down the name of the system image file.
•
Copies a file from flash memory to a server.
Copy the system image file to a server to serve as a
•
backup copy.
Enter the flash memory partition number if prompted.
•
Enter the filename and destination URL when
•
prompted.
How to Upgrade the System Image
OL-5595-01
23