Cisco 2800 Series Manual page 254

How to Upgrade the System Image
What to Do Next
Proceed to the
Using Console Download (xmodem) in ROM Monitor to Copy the System Image into Flash Memory
Use console download, a ROM monitor function, when you do not have access to a TFTP server.
For detailed information about the console download function and the xmodem ROM monitor
command, see the
Prerequisites
•
•
Restrictions
•
•
•
•
•
SUMMARY STEPS
1.
OL-5595-01
16
"Loading the New System Image" section on page
Xmodem Console Download Procedure Using ROMmon
Download the new Cisco IOS software image to your PC. See the
System Image?" section on page
Connect your PC to the router console port, and launch a terminal emulator program. For examples
of performing this task on similar routers, see the
ROMmon tech note.
If you use a PC to download a Cisco IOS image over the router console port at 115,200 bps, make
sure that the PC serial port uses a 16550 universal asynchronous receiver/transmitter (UART).
If the PC serial port does not use a 16550 UART, we recommend using a speed of 38,400 bps or
lower when downloading a Cisco IOS image over the console port.
The xmodem transfer works only on the console port.
You can only use the xmodem command to download files to the router. You cannot use xmodem
to get files from the router.
Because the ROM monitor console download uses the console to perform the data transfer, error
messages are displayed on the console only after the data transfer is terminated. If an error occurs
during console download, the download is terminated, and an error message is displayed. If you
changed the baud rate from the default rate, the error message is followed by a message that tells
you to restore the terminal to the baud rate specified in the configuration register.
xmodem [-[c][y][r][x]] destination-file-name
2.
Xmodem Console Download Procedure Using
Upgrading the System Image
17.
tech note.
"Where Do I Download the