Honeywell KHF 1050 System Installation Manual page 84

Hf communication system
Hide thumbs Also See for KHF 1050:
Table of Contents

Advertisement

2. Unpacking
Use care when unpacking KHF 1050 HF system components. Open shipping cartons
and carefully remove all items. Check that all items on the packing list are included.
Visually inspect each component for damage incurred during shipment: dents, deep
abrasions, chipped paint, etc. If any component is damaged, notify the transportation
carrier immediately.
3. Pre-installation Testing
All components of the KHF 1050 HF system have been adjusted and tested before
shipment and pre-installation testing is not required. If pre-installation bench testing of
any unit is desired, refer to bench test section of the applicable maintenance manual.
Refer to Paragraph
manuals.
4. Equipment Changes and Markings
A standardized marking system identifies equipment with incorporated modifications.
Refer to the Publication Index for a list of Service Bulletins affecting the various units
in the KHF 1050 HF system.
5. Installation Planning
5.A
General Considerations
General information for installation of the KHF 1050 HF system, instructions for
location of system components, interwiring and cable fabrication, and mode
strapping options are provided in the following paragraphs. Interconnect diagrams
at the end of this section show the interconnection of various system components.
The KHF 1050 HF system should be installed in the aircraft in a manner consistent
with acceptable workmanship and engineering practices and according to
instructions set forth in this publication.
The installer should make a thorough visual inspection and perform the
post-installation and operational checks of the system to ensure that the system
has been properly and safely installed in the aircraft.
CAUTION: AFTER INSTALLATION OF THE CABLING AND BEFORE
INSTALLATION OF THE EQUIPMENT, SUPPLY AIRCRAFT
PRIMARY POWER TO THE CABLES AND CHECK THAT POWER IS
APPLIED ONLY TO THE UNIT CONNECTOR PINS SPECIFIED IN
THE INTERWIRING DIAGRAMS.
Revison 2
N
KHF 1050 SYSTEM INSTALLATION MANUAL
"1.F. Related Publications"
, for a list of related maintenance
23-10-09
Page 2002
Apr/2006

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents