Cisco ONS 15600 Reference Manual page 338

C.3 Node Default Settings
Language One (TL1) reporting of PM data is enabled for cross-connect paths on the node, whether
or not to allow ports to be disabled when they are providing services (when the default is set to
FALSE users must remove or disable the services first, then put the ports out of service), and
whether to report loopback conditions on Out-of-Service, Maintenance (OOS-MT) state ports.
Network settings—Set default gateway node type, and whether to raise an alarm when the backplane
•
LAN cable is disconnected.
OSI settings—Set the Open System Interconnection (OSI) main setup, generic routing
•
encapsulation (GRE) tunnel default, the link access protocol on the D channel (LAP-D), the router
subnet, and the TID address resolution protocol (TARP) settings.
1+1 protection settings—Set whether or not protected circuits have bidirectional switching, are
•
revertive, and what the reversion time is.
BLSR protection settings—Set whether BLSR-protected circuits are revertive, and what the
•
reversion time is, at both the ring and span levels.
• Legal Disclaimer—Set the legal disclaimer that warns users at the login screen about the possible
legal or contractual ramifications of accessing equipment, systems, or networks without
authorization.
Security Grant Permissions—Set default user security levels for activating/reverting software, PM
•
data clearing, database restoring, and retrieving audit logs.
Security Access settings—Set default security settings for LAN access, shell access, serial craft
•
access, element management system (EMS) access (including Internet Inter-Object Request Broker
Protocol [IIOP] listener port number), TL1 access, and Simple Network Management Protocol
(SNMP) access.
Security RADIUS settings—Set default RADIUS server settings for the accounting port number and
•
the authentication port number, and whether to enable the node as a final authenticator.
Security Policy settings—Set the allowable failed logins before lockout, idle user timeout for each
•
user level, optional lockout duration or manual unlock enabled, password reuse and change
frequency policies, number of characters difference that is required between the old and new
password, password aging by security level, enforced single concurrent session per user, and option
to disable inactive user after a set inactivity period.
Security Password settings—Set when passwords can be changed, how many characters they must
•
differ by, whether or not password reuse is allowed, and whether a password change is required on
first login to a new account; set password aging enforcement and user-level specific aging and
warning periods; set how many consecutive identical characters are allowed in a password,
maximum password length, minimum password length, minimum number and combination of
nonalphabetical characters required, and whether or not to allow a password that is a reversal of the
login ID associated with the password.
BITS Timing settings—Set the coding, framing, and state settings for building integrated timing
•
supply 1 (BITS-1) and BITS2 timing.
General Timing settings—Set the mode (External, Line, or Mixed), quality of reserved (RES) timing
•
(the rule that defines the order of clock quality from lowest to highest), revertive, reversion time,
and synchronization status messaging (SSM) message set for node timing.
Note Any node level defaults changed using the Provisioning > Defaults tab, changes existing node level
provisioning. Although this is service affecting, it depends on the type of defaults changed, for example,
general, and all timing and security attributes. The "Changing default values for some node level
attributes overrides the current provisioning." message is displayed. The Side Effects column of the
Defaults editor (right-click a column header and select Show Column > Side Effects) explains the effect
Cisco ONS 15600 Reference Manual, R8.0
C-38
Appendix C Network Element Defaults