Figure 1-10 Bits Timing Connections On The Cap/Cap2; Lan Installation - Cisco ONS 15600 Reference Manual

1.7.3 LAN Installation

Figure 1-10
+
OUT
+
IN
1.7.3 LAN Installation
Use a straight-through LAN cable with the LAN port on the CAP or CAP2 to connect the ONS 15600
to a hub, switch, or a LAN modem for remote access to the node. Use a crossover cable when connecting
the CAP or CAP2 to a workstation. You can also use a straight-through or crossover LAN cable with the
LAN port on the active TSC faceplate to connect directly to the local ONS 15600.
Note Do not use the LAN port on the active TSC card for remote monitoring because you will lose
connectivity to the node if the other TSC card in the shelf becomes the active TSC card.
1.7.4 TL1 Craft Interface Installation
To open a TL1 session using the craft interface on a PC, use the RJ-45 port on the active TSC card to
access the system using a standard web browser. If a browser is not available, you can access the system
using one of the two EIA/TIA-232 ports on the CAP and CAP2. Each EIA/TIA-232 port supports VT100
emulation so that you can enter TL1 commands directly without using a web browser. Because the CAP
and CAP2 EIA/TIA-232 port is set up as a data terminal equipment (DTE) interface, you must use a
3-pair swapping null modem adapter when you are working in a UNIX or PC environment so that the
TXD/RXC, DSR/DTR, and CTS/RTS pins are swapped. Use a standard pin D-sub cable when
connecting to a PC. Refer to the Cisco ONS SONET TL1 Command Guide for more information.
Do not use the LAN port on the active TSC card for remote monitoring because you will lose
Note
connectivity to the node if the other TSC card in the shelf becomes the active TSC card.
Cisco ONS 15600 Reference Manual, R8.0
1-12
BITS Timing Connections on the CAP/CAP2
EXTERNAL
16 15 14 13 12 11 10 9
5
4
3
2
1
10 9 8
FRAME
64k
E1/T1
ALARMS
8 7 6 5
7 6 5 4
Chapter 1 Shelf and Backplane Hardware
4 3 2 1
5
4
3
2
1
3 2 1
GROUND
64k
E1/T1
+
OUT
+
IN