Cisco C880 M4 Server Configuration; Set Up The Cisco Integrated Management Controller; Connect To The Management Board - Cisco C880 M4 Configuration Manual

Cisco C880 M4 Server Configuration

This section describes how to configure the Cisco C880 M4 Server.

Set Up the Cisco Integrated Management Controller

First you need to configure the onboard Cisco Integrated Management Controller (IMC).
1.
2.
Figure 8.
Management Network
Note:
green light before performing the initial setup.

Connect to the Management Board

After you turn on the power, the MMB initialization process starts. During the initialization process, the MMB RDY
LED flashes and the alarm LED of the unit in the front turns on.
After the initialization process is complete, the MMB RDY LED stops flashing and changes to a steady green light.
1.
2.
© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Connect an RS-232 cable to the communications (COM) port.
Connect the user ports (IMC ports) to the customer management network and VLAN to access the IMC
over your web browser (Figure 8). These two ports function as clustered ports.
Cisco C880 M4 MMB Connections
CIMC
RJ-45 Connection
100 MB/S
Customer
After you power on the controller, wait for the ready (RDY) and active (ACT) LEDs to display a steady
Verify that the COM port of the MMB is connected to the technician's system.
Set up the IP address for the IMC. Open a new serial connection using putty with the settings shown in
Table 1.
MMB Connectors View
Ports
RS-232 Cable
Page 13 of 146