Select The Method For Configuring The 16-Gbps Fibre Channel Card - Cisco C880 M4 Configuration Manual

Figure 75.
If you don't perform this step, the dump device is not added.
Note that you cannot mix different 16-Gbps Fibre Channel card firmware versions in a single server. You also
cannot mix different boot BIOS driver versions in a single partition. If you have different versions of the 16-Gbps
Fibre Channel card firmware or UEFI driver, install the same version of the firmware driver in the server and
partition.

Select the Method for Configuring the 16-Gbps Fibre Channel Card

Check the UEFI driver version from the Device Manager screen of the Boot Manager main page.
1.
2.
© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
From the Boot Selector screen in the Power Control window of the MMB, select "Force boot into EFI Boot
Manager." Then turn on the power. Start the UEFI shell.
The Boot Manager main page appears. Select Device Manager and then press the Enter key (Figure 76).
Page 73 of 146