Cisco Content Server Cluster Configuration - Cisco TelePresence Manual

Chapter 3 Configuring a Cisco Unified Communications Manager SIP Trunk with a Cisco TelePresence
Field
Carrier Identification
Code
Network Service
Service Parameter Name
Service Parameter Value

Cisco Content Server Cluster Configuration

To Content Server cluster configuration:
•
•
•
Complete these steps in the order given:
Create a Route Group (for a TCS Cluster)
Step 1
On the Call Routing menu, click Route/Hunt > Route Group.
Step 2
On the Find and List Route Groups page, click Add New.
Step 3
On the Route Group Configuration page, enter the following settings.
Field
Route Group Name
Distribution Algorithm
Step 4
Confirm that both SIP trunks appear in the Available Devices field. Otherwise, click Find.
Description
Enter the appropriate carrier identification code (0, 3, or 4 digits) in the
Carrier Identification Code field. Carrier identification codes allow
customers to reach the services of interexchange carriers.
The following list shows examples of commonly used carrier identification
codes:
•
•
•
For a complete list of NANP carrier identification codes, go to
http://www.nanpa.com/.
Choose the appropriate network service. The values vary depending on the
network service protocol that you choose from the Network Service
Protocol field.
This field displays the service parameter name that is associated with the
chosen network service. If no service parameter exists for the network
service, the field displays <Not Exist>.
Enter the appropriate service parameter value. Valid entries include the
digits 0 through 9. If a service parameter does not exist for the network
service, Cisco Unified CM Administration disables this field.
Create the SIP Trunk Security Profile
To Create the SIP Profile
Create the SIP Trunk
Setting
Enter Route Group name.
Click Top Down.
Cisco TelePresence Content Server Release 6.2.1 Administration and User Guide
ATT—0288
Sprint—0333
WorldCom/MCI—0222
CUCM Integration with Content Server 6.2
3-33