Cisco C880 M4 Configuration Manual page 106

3.
Figure 119. Fabric Point to Point Setting Screen
Set the Link Speed
Configure the setting that corresponds to the connection kink speed (2, 4, or 8 Gbps). Do not set Auto Select
(Default).
1.
© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
When you connect a 16-Gbps Fibre Channel card to storage that supports 16 Gbps, you have to connect
through a Fibre Channel switch. Note that conventional FCAL connection is not supported in this case.
Confirm the SAN connection configuration and select the appropriate setting. Then press the Enter key.
Change the setting from Auto Topology: Loop First (Default) by referring to the connection settings in
Figure 119.
In the main menu, select Configure Advance Adapter Parameters and press the Enter key (Figure 120).
Page 106 of 146