Install Emulex Onecommand Manager; Install The Multipath Driver; Restore The Multipath Connection - Cisco C880 M4 Configuration Manual

Figure 136. Change Boot Order Menu for Cisco C880 M4
4.
5.

Install Emulex OneCommand Manager

Now install Emulex OneCommand Manager (OCManager).
1.
2.
3.
Note:

Install the Multipath Driver

Install the multipath driver. For the installation procedure, refer to the manual for the multipath driver that you are
using.

Restore the Multipath Connection

Recover the multipath connection.
The OS is shut down, the cable of the Fibre Channel passing cut according to procedure 1 is reconnected after the
power supply of the partition is cut, and the OS is started. After it shuts down after the start by the multipath is
confirmed, internal hard-disk drive (HDD) into is added when internal HDD into is used.
© 2017 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Specify Commit Changes and Exit.
Specify Reset System to reboot the partition.
If you install OCManager, you will need to install the Linux libnl package. Use the Fibre Channel card
driver utility and install OCManager. OCManager includes the libnl package.
Copy the binary files on the Cisco C880 M4 Server's optional directory.
For information about how to install OCManager, refer to the installation procedure for the original
equipment manufacturer (OEM) driver.
One end of the Fibre Channel cable is still off the connector at this point.
Page 119 of 146