Honeywell THOR VM1 User Manual page 130

Logon Options
There are two options available, a
as the credentials for 802.1x authentication and a
tials for 802.1x authentication before Windows logon.
If either option is enabled, the credentials entered here take precedence over any credentials entered on the profile
tab.
To use either option, select Logon Options from the Property list which activates the Logon Options button.
Click the Logon Options button.
Single Signon
To use the Single Signon option, select the checkbox for Use the Windows username and password when
available. When the active profile is using LEAP, PEAP-MSCHAP, PEAP-GTC or EAP-FAST, the SCU ignores the
username and password, if any, saved in the profile. Instead, the username and password used for Windows
logon is used. Any certificates needed for authentication must still be specified in the profile.
Click OK then click Commit.
Pre-Logon Connection
To use the Pre_logon connection, select the checkbox for Enable pre-logon connection. This option is designed to
be used when:
• EAP authentication is required for a WLAN connection
• Single Signon is configured, so the Windows username and password are used as credentials for EAP
authentication
• The WLAN connection needs to be established before the Windows login.
Once this option is enabled, the Authentication delay and Association timeout values can be adjusted as nec-
essary. Both values are specified in milliseconds (ms).
The default authentication delay is 5000 ms and the valid range is 0 - 600,000 ms.
The default association timeout is 10,000 ms and the valid range is 10,000 to 600,000 ms.
6 - 14
Single Signon (page 6-14) option which uses the Windows username and password
Pre-Logon Connection (page 6-14) option which uses saved creden-