Chapter 2 Card Reference
2.10 SFP/XFP Modules
Figure 2-12
shows the Filler card body and faceplate.
Figure 2-12
ONS 15600 SDH Filler Card
2.10 SFP/XFP Modules
This section describes the SFPs that provide the fiber interface to the ONS 15600 SDH ASAP card when
used with the 4PIO modules. A line rate (STM-1, STM-4, STM-16, or Gigabit Ethernet) must be
assigned to each SFP in the CTC software interface or using TL1. In CTC, SFPs are known as pluggable
port modules (PPMs). To provision PPMs, refer to the Cisco ONS 15600 SDH Procedure Guide.
Note
For information about XFPs, which allow you to provision an STM-64 line rate when used with the 1PIO
module, see the
"2.10.1 XFP Description" section on page
2-28.
Table 2-21
lists the SFPs (PPMs) that are compatible with the ASAP card.
Cisco ONS 15600 SDH Reference Manual, Release 9.0
2-26
78-18400-01