Network Timing - Cisco ONS 15600 Reference Manual

6.2 Network Timing

6.2 Network Timing
Figure 6-1
timing references are Stratum 1 timing sources wired to the BITS input pins on the Node 1 backplane.
The third reference is set to internal clock. The BITS output pins on the backplane of Node 3 are used
to provide timing to outside equipment, such as a digital access line access multiplexer. In the event of
a failure of one of the TSC modules, the redundant TSC module provides timing for BITS Out. There
are some restrictions on the provisioning of BITS Out:
If the system is BITS timed:
•
•
If system is line timed:
•
•
If the system is in mixed mode:
•
•
In the example, Slots 11 and 12 of Node 1 contain the trunk (span) cards. Timing at Nodes 2, 3, and 4 is
set to line, and the timing references are set to the trunk cards according to the distance from the BITS
source. Reference 1 is set to the trunk card closest to the BITS source. At Node 2, Reference 1 is
Slot 11/Port 1 because it is connected to Node 1. At Node 4, Reference 1 is set to Slot 12/Port 1 because
it is connected to Node 1. At Node 3, Reference 1 could be either trunk card because they are at an equal
distance from Node 1.
Cisco ONS 15600 SDH Reference Manual, Release 9.0
6-2
shows an ONS 15600 SDH network timing example. Node 1 is set to external timing. Two
BITS-1 Out can have one reference if a 1+1 protected pair is chosen, or two references if unprotected
line sources are chosen.
BITS-2 Out can have one reference if a 1+1 protected pair is chosen, or two references if unprotected
line sources are chosen.
BITS-1 Out can have one unprotected line source and either or both of the network element (NE)
references.
BITS-2 Out can have one unprotected line source and either or both of the NE references.
BITS-1 Out can have one unprotected line source and any line source selected as NE reference Ref-1
or Ref-2.
BITS-2 Out can have one unprotected line source and any line source selected as NE reference Ref-1
or Ref-2.
Chapter 6 Timing
78-18400-01