Scenario 3: Using Proxy Arp To Enable An Ons 15600 Sdh Gateway - Cisco ONS 15600 Reference Manual

9.2.3 Scenario 3: Using Proxy ARP to Enable an ONS 15600 SDH Gateway

Figure 9-2 Scenario 2: CTC and ONS 15600 SDHs Connected to Router
CTC Workstation
IP Address 192.168.1.100
Subnet Mask 255.255.255.0
Default Gateway = 192.168.1.1
Host Routes = N/A
ONS 15600 SDH #1
IP Address 192.168.2.10
Subnet Mask 255.255.255.0
Default Router = 192.168.2.1
Static Routes = N/A
9.2.3 Scenario 3: Using Proxy ARP to Enable an ONS 15600 SDH Gateway
Scenario 3 is similar to Scenario 1, but only one ONS 15600 SDH (Node 1) connects to the LAN
(Figure
communications channel (DCC). Because all three ONS 15600 SDHs are on the same subnet, Proxy
ARP enables Node 1 to serve as a gateway for Nodes 2 and 3.
Note This scenario assumes that all CTC connections are to Node 1. If you connect a laptop to either Node 2
or Node 3, network partitioning will occur; neither the laptop or the CTC computer will be able to see
all nodes. If you want laptops to connect directly to end network elements (ENEs), you will need to
create static routes (refer to the
page
ONS 15600 SDH Proxy Server" section on page
Cisco ONS 15600 SDH Reference Manual, Release 9.0
9-4
LAN A
Int "A"
Int "B"
ONS 15600 SDH #2
IP Address 192.168.2.20
Subnet Mask 255.255.255.0
Default Router = 192.168.2.1
Static Routes = N/A
SDH RING
9-3). Two ONS 15600 SDHs (Nodes 2 and 3) connect to Node1 through the SDH data
9-6) or enable the ONS 15600 SDH proxy server (see the
Router
IP Address of interface "A" to LAN "A" 192.168.1.1
IP Address of interface "B" to LAN "B" 192.168.2.1
Subnet Mask 255.255.255.0
Default Router = N/A
Host Routes = N/A
ONS 15600 SDH #3
IP Address 192.168.2.30
Subnet Mask 255.255.255.0
Default Router = 192.168.2.1
Static Routes = N/A
"9.2.5 Scenario 5: Using Static Routes to Connect to LANs" section on
9-11).
Chapter 9 Management Network Connectivity
LAN B
"9.2.7 Scenario 7: Provisioning the
78-18400-01