Entering Auxiliary Input Curve Data - GE Moisture monitor series 3 Programming Manual

Entering Auxiliary Input
Curve Data
Advanced Programming
Aux Curve Menu
[S/N] #PTS CURVE
Note: S/N is not available in this menu.
Aux Curve Menu
S/N [#PTS] CURVE
Enter Total #PTS
2
Note: For linear devices only two data points are required; a
maximum of eight data points may be entered for other
devices. Each data point requires a current or voltage value
with a corresponding scale value in the units you want to
output.
Aux Curve Menu
S/N #PTS [CURVE]
# mA/VDC Units
2 +0.000 0.000
# mA/VDC Units
2 +1.000 0.000
.
# mA/VDC Units
2 +1.000 20.000
Repeat the last three steps to enter the remaining data.
1
Use the arrow keys to move the
brackets to AUX1 (or AUX2),
depending on where the sensor is
connected, and press
1
Use the arrow keys to move the
brackets to #PTS and press
1 Enter the number of data points
and press [YES]. Then press
[NO]
to return to the Curve Menu.
1 Use the arrow keys to move the
brackets to CURVE and press
[YES].
1 If you want to begin entering
data at the data point displayed,
press the right arrow key to
move the bracket to X1 (mA or
V). Otherwise, enter the desired
data point number. Press
and press the right arrow key.
Enter the mA/VDC value. Press
1
[YES]
and press the right arrow
key.
1
Enter the units value and press
[YES].
March 2008
[YES].
[YES].
[YES]
3-45