Displaying Measurements - GE Moisture monitor series 3 Programming Manual

Displaying
Measurements
Basic Programming
The MMS-3 begins displaying measurements immediately after
power-up. It provides two lines in order to display measurements.
You may select the measurement mode for each line as described in
the procedure below.
Since the display has a limited amount of space, the MMS-3 uses
abbreviations to represent the displayed measurement mode and units
as shown in Table 2-3 on page 2-5.
[MODE]
Press the key to enter the Modify DSP Mode.
Display Page: 1
Press YES to Edit
Modify DSP Mode
LINE1 [LINE2]
Line 2 DSP Mode
[CH 1] CH 2
Select DSP Mode
[H] T P Aux1
The MMS-3 can display six
pages of measurements, each
showing two different
parameters. Use the numeric
keys to enter the desired page
[YES]
and press .
P1
Use the arrow keys to move the
brackets to the desired line you
want to edit and press
P1 Use the arrow keys to move the
brackets to the desired channel
you want to display and press
[YES]
.
P1
Use the arrow key to move the
brackets to the measurement
[YES]
mode and press
Table 2-1 on page 2-4 for a list
of the available measurement
modes.
March 2008
[YES]
.
. See
2-3