Recording With External Audio - Example - Honeywell ECC-50/100 Instruction Manual

Recording Custom Messages
3. Enter programming mode at the main control board.
4. Enable Recording Mode in the system's message recording programming section. Refer to
Section 3.5.1 on page 71.
NOTE: The display board will light green LEDs for message slots that are occupied. If a
message is already stored in that message slot, it must first be erased prior to recording a new
message. See Section 3.5.4.
5. Press zone button 17 to record. Then press zone button 1-14 that will be the designated
message slot. The yellow zone LED will blink.
6. Simultaneously, press zone button 19 and start the external audio channel. The yellow zone
LED will be on steady.
7. When the audio file from the PC is finished playing, press zone button 19 again. The green
zone LED will light and the yellow zone LED will turn off.
8. Press the zone button that was previously selected in step 5 to play back your recorded
message.
9. Enter programming mode again and deselect Message Record Mode.

Recording with External Audio - Example

To record into message slot 2 via the external audio input:
Enter the Local Recording mode via the the online programming utility. Select the Message Record
Mode option. The display board will light green zone 1-14 LEDs for all message slots that are
occupied.
If a message already exists in message slot 2, it must first be erased. Press zone button 24, then
zone button 2. (See Section 3.5.4
turn off.
To record the message, press zone button 17, then zone button 2. The yellow zone LED will blink.
Press zone button 19 and PLAY on the PC simultaneously to start recording. When the PC message
is done, press zone button 19 again to stop recording. The yellow zone LED 2 will stay lit until
completed. The green LED for zone button 2 will light after the recording is complete.
Enter programming mode again and deselect Message Record Mode.
Press zone button 2
to select message
slot 2.
Emergency Command Center Manual — P/N LS10001-000FL-E:G 5/3/2016
) When the message has been erased, the green zone LED will
.
Figure 3.1 External Audio Example
Programming
Press zone button
17 to record.
Press zone button
19 to start and stop
recording.
73