2: External Audio Input - Honeywell ECC-50/100 Instruction Manual

Programming
When in Local Record mode, the display board's LEDs will function as follows:
Zone Button 1-14 Green LED
Zone Button 1-14 Yellow LED
Zone Button 1-14 Green LEDs
3.5.2 External Audio Input
The external audio input allows customized, pre-recorded messages to be loaded into a message
slot.
1. Wire a speaker cable with 1/8" mini plug (Radio Shack p/n 42-2454) to EXT Audio GND and
IN terminals on the display board.
2. Plug the mini plug into the Line Out/Headphone Jack on a PC or laptop. See Figure 3.15.
external audio
72
LED Active LED Status
Display
Board
1 (GND)
TB5
2 (+)
input
Figure 3.15 External Audio Connection for Recording
Emergency Command Center Manual — P/N LS10001-000FL-E:G 5/3/2016
Button
zone
buttons
Zone
1-14
Button 17
zone
Zone
buttons
Button 19
17, 19, 24
The associated
yellow LEDs for
Zone
these buttons turn
Button 24
on to indicate
being pressed.
On Message is currently programmed in this slot.
On LED will turn on until recording is complete or
the 1 minute slot is full.
Off Slot is available to record.
Recording Custom Messages
Function
Select message slot
Start and stop recording
from External Audio
Input terminals
Erase selected message
slot
Meaning