Makita LS1016 Technical Information page 6

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Blade case, Motor section
DISASSEMBLING
Note: Refer to Fig. 7. The three notches on Blade case have
important role for disassembly / assembly.
(1) Disconnect the linkage of Blade case with Arm and Base
section by removing Strain relief and Link plate as
illustrated in Figs. 8 and 9.
Fig. 8
Aligning notch B with Stopper pin, push Knob 20 toward the notch.
Blade case can be locked at starting position.
Blade case
Knob 20
Remove M4x10 Pan head screw (2pcs.) for Guard as illustrated below
and then separate Guard section.
Guard section
Fig. 9
Remove Link plate as illustrated below.
Link plate
complete
notch B
Stop ring E-5
Flat washer 6
Ring 6
Fig. 7
Blade case
notch A: locking Blade case to
notch B: locking Blade case
notch C: locking Blade case
Remove Strain reliefs from Arm complete and
Blade case by unscrewing 4x12 Tapping screw
(2pcs.).
4x12 Tapping screw
1. Remove Stop ring E-5, Flat washer 6 and Ring 6.
Link plate complete can be free from blade case.
2. Remove M6x20 Hex socket head bolt, Flat washer 6
and Ring 6. Link plate complete can be free from
Front arm.
M6x20 Hex socket head bolt
Flat washer 6
Ring 6
P 6/ 37
Base at 90 degrees
at starting position
at the lowest position
Strain relief
4x12 Tapping screw
Strain relief
M4x10 Pan head screw
(2pcs.)