Makita LS1016 Technical Information page 16

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-4. Safety cover A
ASSEMBLING
(1) Assemble Safety cover A section as illustrated in Fig. 34. And then mount the Safety cover A section to Safety cover B
as illustrated in Fig. 35.
(2) Mount the Safety cover section to Blade case complete as illustrated in Fig. 36.
Fig. 34
After applying grease to Torsion
spring 45, set the tails to Safety
cover A as illustrated below.
Torsion spring 45
Safety cover A
Fig. 35
Mount the Safety cover A section
to the Safety cover B by tightening
with 4x12 Tapping screw (3pcs.).
Fig. 36
Tighten Center cover with
Hex flange head bolt M8x12.
But reserve the allowance
to move the Center cover.
Put Center washer on the Torsion
spring 45, fitting its five holes
to the five bosses of Safety cover A.
Boss
(5points)
Apply Grease to this portion which
contacts the hole of Center cover .
Center cover
Safety cover A
Move Center cover until its
protrusion touches the flange of
M8x12 Hex flange head bolt.
After mounting Center cover,
assemble Center plate, fitting
its five holes to five bosses of
Safety cover A .
Center plate
Center
washer
4x12 Tapping
Screw (3pcs.)
Safety cover B
Tighten Center cover with
Hex flange head bolt firmly.
P 16/ 37
Center
cover