Makita LS1016 Technical Information page 18

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-6. Positive lock mechanism of Turn base
DISASSEMBLING
(1) Remove Stop ring E-7. (Fig. 40)
Grip 50, Compression spring 11, Flat washer 10 and Cam
can be removed.
(2) Remove M6x14 H.S.Binding head screw then remove
Miter lock plate in the direction designated with black
arrow. (Fig. 41)
(3) Remove CT 4x16 Tapping screw (2pcs.) and Lock lever
plate. (Fig. 42)
(4) Push Lock pin 6 in the direction designated with black
arrow and pick up Lock lever in the direction designated
with gray arrow. (Fig. 43)
(5) Remove Pin 3 from Lock pin 6, then pull out Lock pin 6 in
the direction designated with black arrow. (Fig. 44)
Fig. 41
M6x14 H.S.Binding
head screw
Turn base
Fig. 43
Lock lever
ASSEMBLING
Assemble Turn base section as illustrated in Fig. 45. And then, take the disassembling step in reverse. Refer to Fig. 37.
Fig. 45
Apply Grease to Slide plate and the center hole
of Base before assembling Turn base section.
Slide plate
Miter lock plate
Compression spring 13
Pin
Miter lock plate
Miter lock plate can be pulled out
without removing Pin.
Lock pin 6
Turn base section has to be tightened with M8x45 Hex bolt
so that it can smoothly turn without wobbling.
Base
Fig. 40
Stop ring E-7
Compression spring 11
Flat washer 10
Grip 50
Fig. 42
Lock lever plate
Fig. 44
Compression Pin 3
spring 6
M8x45 Hex bolt
Flat washer 8
P 18/ 37
Cam
Turn base
Groove for Stop ring E-7
CT4x16
Tapping screw
(2pcs.)
Lock pin 6
Lock lever
While pressing down Lock
lever, fit Turn base section
to Base.