Installation - Honda 08E91-E22-100B Installation Instructions Manual

Illustration of the Remote Engine Starter System
Installed on the Vehicle
RELAY
(5-PIN)
2 FUSES
40A
3 RELAYS
(4-PIN)

INSTALLATION

Customer Information: The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
"do-it-yourselfers."
NOTE: This antenna should be installed only if the
ambient air temperature 15°C (60°F) or above.
1. Make sure you have the anti-theft code for the radio,
then write down the radio station presets.
2. Disconnect the negative cable from the battery.
© 2010 American Honda Motor Co., Inc. – All Rights Reserved.
ANTENNA
ENGINE
STARTER
HARNESS
CONTROL
UNIT
872601AT
2 FUSES 3A
AII 44399 (1008)
Setting the Control Unit
3. Get the control unit. Using a small flat-tip
screwdriver, set the switches on the control
unit to the positions shown. Using isopropyl
alcohol on a shop towel, clean the area where
the protective tape will attach. Attach the
protective tape to the control unit over the switches.
NOTE:
• The switches must be set before the
control unit is plugged in.
• If the switch settings are not correct, the
engine starter will not operate correctly.
• If you are setting the switches when the
control unit is installed in the vehicle, touch a
metal part of the screwdriver to a metal part
of the vehicle beforehand to discharge any
static electricity.
• If you change the switch settings with the unit
connected, you must disconnect the unit then
reconnect it before the new settings are
recognized.
CONTROL
UNIT
SMALL
FLAT-TIP
SCREW-
DRIVER
SWITCHES
SWITCHES
SW:1 RR Junction unit -----------------------> OFF
SW:2 Trunk or Tailgate ----------------------> OFF
SW:3 Smart Entry -----------------------------> OFF
SW:4 Horn or Buzzer Answerback ------> OFF
SW:5 Trunk Main SW -------------------------> OFF
SW:6 Reserve ----------------------------------> ON
Discharge any
static electricity.
The switches must
be set before the
control unit is
plugged in.
SET
3 of 21