Installation - Honda 08E91-E22-100B Installation Instructions Manual

Illustration of the Remote Engine Starter System
Installed on the Vehicle
RELAY
(5-PIN)
2 FUSES
40 A
3 RELAYS
(4-PIN)

INSTALLATION

Customer Information: The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
"do-it-yourselfers."
NOTE: This antenna should only be installed if the
ambient air temperature 15°C (60°F) or above.
1. Make sure you have the anti-theft code for the radio,
then write down the radio station presets.
2. Disconnect the negative cable from the battery.
© 2009 American Honda Motor Co., Inc. – All Rights Reserved.
ANTENNA
ENGINE
STARTER
HARNESS
CONTROL
UNIT
872601AT
2 FUSES 3 A
AII 42460 (0908)
Setting the Control Unit
3. Get the control unit. Using a small flat-tip
screwdriver, adjust the switches on the control
unit to the locations shown. Using isopropyl
alcohol on a shop towel, clean the area where the
protective tape will attach. Attach the protective
tape to the control unit over the switches.
NOTE:
• The switches must be selected before the
control unit is plugged in.
• If the switch setting is not correct, the engine
starter will not operate correctly.
• If setting the switches when the control unit is
installed in the vehicle, touch a metal part of
the screwdriver to a metal part of the vehicle
to discharge any static electricity.
• If you change the switch settings with the unit
connected, you must disconnect the unit, then
reconnect it before the settings will change.
CONTROL
UNIT
SMALL
FLAT-TIP
SCREW-
DRIVER
SWITCHES
SWITCHES
SW:1 RR Junction unit -----------------------> OFF
SW:2 Trunk or Tailgate ----------------------> OFF
SW:3 Smart Entry -----------------------------> OFF
SW:4 Horn or Buzzer Answerback ------> OFF
SW:5 Trunk Main SW -------------------------> OFF
SW:6 Reserve ----------------------------------> ON
Discharge any
static electricity.
The switches must
be selected before
the control unit is
plugged in.
SET
3 of 21