Tools And Supplies Required; Installation; Illustration Of The Engine Starter System Installed On The Vehicle - Honda 08E91-E22-100B Installation Instructions Manual

7 Foam cushion tapes
Flange nut
Clip
Green relay (5-pin)
Template
Illustration of the Engine Starter System Installed
on the Vehicle
RELAY
(5-PIN)
2 FUSES 40 A
3 RELAYS
(4-PIN)
2 of 22
www.collegehillshonda.com
ANTENNA
ENGINE
STARTER
HARNESS
CONTROL
UNIT
2 FUSES 3 A
7507010T

TOOLS AND SUPPLIES REQUIRED

Phillips screwdriver
Long blade flat-tip screwdriver
Small flat-tip screwdriver
6 mm Hex wrench
T25 Torx bit
3 mm and 7 mm Drill bit
File
Ratchet
10 mm Socket
Combination wrench
Isopropyl alcohol
Shop towel
Tape measure
Clip remover
Diagonal cutters
Felt-tip pen
Center punch
Scissors
2 Pairs of needle nose pliers
Rubber mallet
HDS (Honda Diagnostic System)
Masking tape
Safety goggles

INSTALLATION

Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by "do-it-yourselfers."
NOTE: The antenna should only be installed if the
ambient air temperature 15°C (60°F) or above.
1. Make sure you have the anti-theft code for the
radio, then write down the radio station presets.
2. Disconnect the negative cable from the battery.
AII 38215-38958 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved.