Honda 08E91-E22-100B Installation Instructions Manual page 14

Without driver's dashboard under cover, go to
step 48.
With driver's dashboard under cover, continue
with step 46.
46. Measure the indicated dimension on the instrument
panel and mark with a felt-tip pen and a punch.
INSTRUMENT
PANEL
View from below
FRONT
6 mm
(0.2 in.)
47. While wearing eye protection, drill a 3 mm hole,
and then a 7 mm hole at the marked position of the
instrument panel. Using a file, remove any burrs at
the edge of the hole you made.
INSTRUMENT PANEL
14 of 21
12 mm
(0.5 in.)
PUNCH
FELT-TIP
PEN
DRILL BIT
(3 mm, 7 mm)
DRILL
48. Secure the engine starter harness to the instrument
panel using a wire tie.
• With driver's dashboard under cover: Secure
in the hole you drilled in the instrument panel.
• With Driver's dashboard under cover: Secure
through the existing hole.
FUSE BOX
872636AT
49. Use the clip on the engine starter harness to secure
the engine starter harness to the fuse box.
50. Disconnect the vehicle 42-pin, 4-pin, and 2-pin
connectors.
FUSE BOX
VEHICLE 42-PIN
CONNECTOR
872637AT
AII 44399 (1008)
WITH DRIVER'S DASHBOARD
UNDER COVER
CLIP
VEHICLE 4-PIN
CONNECTOR
VEHICLE 42-PIN
CONNECTOR
FUSE BOX
FRONT VIEW
VEHICLE 2-PIN
CONNECTOR
VEHICLE 4-PIN
CONNECTOR
LOCK
© 2010 American Honda Motor Co., Inc. – All Rights Reserved.
WIRE
TIE
872638AT
VEHICLE 2-PIN
CONNECTOR
872639AT