Running Calibrators And Reagent Baselines (Rbl); Running Control Samples - Siemens ADVIA 2400 Operator's Manual

Running calibrators and reagent baselines (RBL)

1. Select
number.
2. Select
You can select both calibration types.
3. Select
4. To remove any tests you do not want calibrated in this run, select
5. To remove any calibrators you do not want used in this run, select
select
To run only a reagent baseline (RBL) or blank rate, select only the blank solution.

Running control samples

1. Select
2. To remove any tests you do not want run on the controls, select
3. To remove any controls you do not want used in this run, select
select
From STT
1. Make sure the samples are loaded.
2. In the Ordinary sample area, next to Routine smp, select
This activates other fields.
3. To specify how the samples are identified, in the Ordinary sample area, next to
Analyze mode, select
If you select
You can choose to scan for a single tray position or for a range of positions as
follows:
4. In the boxes to the right of Analyze, enter the range of positions you want to scan.
For example: If you enter 50 and 60. The system scans for barcodes within this range
and will aspirate only from positions at which it found barcodes.
If you want the system to aspirate sample from a specific position or specific range of
positions, select
Enter the tray number.
In the boxes to the right of Analyze, enter the position or range of positions from
where you want the system to aspirate samples.
80
Multipnt.smp. Analyze
One-pnt.smp. Analyze
. or
Ordinary calib Special calib
.
.
Control smp. Analyze
.
Barcode
, the system scans the entire STT tray for barcodes.
Barcode
.
Cup posi
, then select or
TT No. 98
.
.
or
Cup posi.
to select the STT tray
99
Temp.item select
Temp.sample
Temp.item select
Temp.sample
.
Analyze
ADVIA 2400 Operator's Guide
.
.