Cleaning The Chiller Filter - Siemens ADVIA 2400 Operator's Manual

NOTE:
least once a month.
1. Unscrew the filter cap at the front top of the cuvette wash bottle (
tube with the filter.
2. Disconnect the cuvette wash bottle level sensor connector, then turn it counter-
clockwise and pull it out.
3. Remove the bottle.
CAUTION
Make a note of the bottle position on the shelf, to avoid mixing up the fluid bottles.
4. Empty the remaining contents of the bottle.
5. Rinse the bottle with deionized water and drain well.
CAUTION
Ensure that the level sensor connector does not get wet, to avoid damaging it.
6. Refill the bottle with cuvette wash solution.
7. Return the bottle to the same position on the shelf in the cabinet.
8. Connect the cuvette wash bottle level sensor connector, then push the connector in
and turn it clockwise.
9. Insert the filter and hose, then fasten the cap.
NOTE:
10. Prime the fluid lines:
NOTE:
a. At the Operation Panel, select the Prime button.
b. At the PRIME Settings dialog box, select Prime 2 and then type 10 or more for
c. Select Execute.

Cleaning the chiller filter

Materials required:
• Vacuum cleaner
Time: 10 minutes
Analyzer mode: STANDBY
NOTE:
cabinet. It must be accessed through the panel door on the right side of the analyzer.
1. Set the analyzer to Standby.
2. On the front right side of the analyzer, push and release the panel door to gain access
to the chiller unit.
130
The cuvette wash bottle may be cleaned when it is refilled, but must be cleaned at
Make sure that the filter holder is located at the bottom of the bottle.
If you are cleaning other bottles, wait to perform this step for all fluid lines.
the number of times in all fields.
The chiller filter is located on the right inside bottom shelf of the analyzer
), then pull up the
4
BIOHAZARD
Wear personal protective
equipment.
Use universal precautions.
ADVIA 2400 Operator's Guide