Sony HVO-1000MD User Manual page 97

[Tally Lamp]
Configure this to indicate the recording status via
the tally lamp on the monitor.
[2D/3D Select]
Configure this when displaying 3D images on a
Sony LMD-2451MT medical monitor.
This mode setting is used to display the [MENU]
screen properly during 3D image display.
The pin assignment screen appears.
5 Use the V and v buttons to select a pin number, and
press the ENTER button.
From the eight pins on the monitor connector,
assign one pin each for camera signal inputs
(endoscopic image inputs), recorder signal inputs
(image inputs from this unit), the recording status
tally lamp (tally lamp on/off), and 2D/3D selection
control.
Notes
• Pin number 5 is reserved for GND and cannot be
selected.
• Pin assignment settings will vary depending on
the monitor. Refer to the operating instructions
for your monitor.
• When performing 2D/3D selection control,
playback status and recording status will not be
displayed properly. Set [Show Play Status] and
[Show Rec Status] to [No] in the [System Admin
Settings] screen - [Function Settings] screen -
[General] tab.
The [Advanced] screen appears again.
6 When you finish configuration, use the V and v
buttons to select [Apply], and press the ENTER
button.
The [Contact Switch] tab appears again.
4
To configure settings in other tabs, use the V , v , B ,
and b buttons to select a tab.
If you are finished configuring [Function Settings],
use the V , v , B , and b buttons to select [Apply], and
press the ENTER button to save the configurations.
97
Device Settings