Sony HVO-1000MD User Manual page 5

Important EMC notices for use in the medical environments
• The HVO-1000MD/3000MT needs special precautions
regarding EMC and needs to be installed and put into
service according to the EMC information provided in
this instructions for use.
• The portable and mobile RF communications equipment
such as cellular phones can affect the HVO-1000MD/
3000MT.
Type of cable
AC mains cable
Y/C In port cable
COMPOSITE IN port cable
DVI-D Input port cable
HD-SDI INPUT cable
PARALLEL REMOTE port (8pin) cable
SERIAL REMOTE port cable
VIDEO OUT port cable
S-VIDEO OUT port cable
DVI-D OUT port cable
YPbPr OUT port cable
HD SDI OUT #1 port cable
FS/TRIG port cable
LAN cable
USB cable
RGB cable
Sound cable
Sound cable
Serial cable
Guidance and manufacturer's declaration-electromagnetic emissions
The HVO-1000MD/3000MT is intended for use in the electromagnetic environment specified below.
The customer or the user of the HVO-1000MD/3000MT should assure that it is used in such an environment.
Emission test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
WARNING
If the HVO-1000MD/3000MT should be used adjacent to
or stacked with other equipment, it should be observed to
verify normal operation in the configuration in which it
will be used.
WARNING
The use of accessories and cables other than those
specified, with the exception of replacement parts sold by
Sony Corporation, may result in increased emissions or
decreased immunity of the HVO-1000MD/3000MT.
List of cables used for EMC tests
2 m, non-shielded
2 m, non-shielded
10 m, shielded
10 m, shielded
10 m, shielded
15 m, non-shielded
1.5 m, non-shielded
1.5 m, shielded
2 m, non-shielded
3 m, shielded
3 m, shielded
1.5 m, shielded
2 m, non-shielded
2 m, shielded
0.5 m, shielded
1.5 m, shielded
2 m, non-shielded
2 m, non-shielded
3 m, non-shielded
Compliance
The HVO-1000MD/3000MT uses RF energy only for its
internal function. Therefore, its RF emissions are very low
Group 1
and are not likely to cause any interference in nearby
electronic equipment.
The HVO-1000MD/3000MT is suitable for use in all
Class B establishments, including domestic establishments and
those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic
purposes.
Class A
Complies
Specifications
Electromagnetic environment-guidance
5