[Pinp] Tab - Sony HVO-1000MD User Manual

[DVI Input Range]
Select between limited and full range for the range
mode during DVI input.
The tonal range for [Limited Range] is 16 to 235, and
the tonal range for [Full Range] is 0 to 255.
The default setting is [Full Range].
[Automatic Pause]
Select whether to automatically pause recording when
there is no input signal.
The default setting is [No].
If you select [Yes], recording will pause if there is no
input signal for 10 minutes.
3
To configure settings in other tabs, use the V , v , B ,
and b buttons to select a tab.
If you are finished configuring [Function Settings],
use the V , v , B , and b buttons to select [Apply], and
press the ENTER button to save the configurations.

[PinP] Tab

Configure initial settings for the PinP (picture-in-picture)
function.
Notes
• When the HVO-3000MT is set to 3D mode, the [PinP]
tab does not appear.
• When the PinP function is enabled, the [Pass-Through]
setting will be disabled.
1
Use the B and b buttons to select the [PinP] tab.
2
Configure each setting.
Select an item using the V and v buttons, and press the
ENTER button to display the setting screen for that
item.
86
Function Settings
[PinP]
Select whether to use the PinP function to display a
PinP inset of RGB inputs in the setting screen that
appears, and press the ENTER button.
You can display PinP insets of RGB inputs for images
currently recording, streaming images, or both.
The default setting is [Not Used].
Notes
• The supported resolutions for RGB input are 640 ×
480, 800 × 600, 1024 × 768, and 1280 × 1024.
• Images will be recorded in HD mode when the PinP
function is enabled.
[Not Used]
Disable use of RGB signals for the PinP function.
[Recording]
Display insets in images that are recording.
[Streaming]
Display insets in images that are streaming.
[Recording and Streaming]
Display insets in images that are recording and
images that are streaming.
[Position]
This setting can be configured when a setting other
than [Not Used] is selected for [PinP].
Select the display position for the inset in the setting
screen that appears, and press the ENTER button.
The default setting is [Upper Left].