Sony HVO-1000MD User Manual page 2

Owner's Record
The model and serial numbers are located at the rear.
Record these numbers in the space provided below.
Refer to these numbers whenever you call upon your Sony
dealer regarding this product.
Model No. ____________________
Serial No. ____________________
WARNING
To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified personnel
only.
THIS APPARATUS MUST BE EARTHED.
No modification of this equipment is allowed.
To disconnect the main power, unplug the power
plug. When installing the unit, incorporate a
readily accessible disconnect device in the fixed
wiring, or connect the power plug to an easily
accessible socket-outlet near the unit. Do not
position the ME equipment where it is difficult to
unplug the power plug. If a fault should occur
during operation of the unit, operate the
disconnect device to switch the power supply off,
or unplug the power plug.
Symbols on the products
This symbol indicates the equipotential
terminal which brings the various parts of a
system to the same potential.
Refer to the operating instructions
Follow the directions in the operating
instructions for parts of the unit on which
this mark appears.
This symbol indicates the manufacturer, and
appears next to the manufacturer's name and
address.
WARNING
Excessive sound pressure from earphones and headphones
can cause hearing loss.
In order to use this product safely, avoid prolonged
listening at excessive sound pressure levels.
2
This apparatus is provided with a main switch on the rear
panel.
Install this apparatus so that user can access the main
switch easily.
Turn off the main power switch on the rear panel of the unit
to disconnect all power to the unit.
Attention-when the product is installed in
Rack:
1. Prevention against overloading of branch circuit
When this product is installed in a rack and is supplied
power from an outlet on the rack, please make sure that
the rack does not overload the supply circuit.
2. Providing protective earth
When this product is installed in a rack and is supplied
power from an outlet on the rack, please confirm that
the outlet is provided with a suitable protective earth
connection.
3. Internal air ambient temperature of the rack
When this product is installed in a rack, please make
sure that the internal air ambient temperature of the
rack is within the specified limit of this product.
4. Prevention against achieving hazardous condition due
to uneven mechanical loading
When this product is installed in a rack, please make
sure that the rack does not achieve hazardous condition
due to uneven mechanical loading.
5. Install the equipment while taking the operating
temperature of the equipment into consideration
For the operating temperature of the equipment, refer to
the specifications of the Operation Manual.
6. When performing the installation, keep the following
space away from walls in order to obtain proper exhaust
and radiation of heat.
Right, Left : 4 cm (1.6 inches) or more
Rear : 40 cm (16 inches) or more
When installing the installation space must be secured in
consideration of the ventilation and service operation.
• Do not block the ventilation slots at the left side and right
side panels, and vents of the fans.
• Leave a space around the unit for ventilation.
• Leave more than 40 cm of space in the rear of the unit to
secure the operation area.
When the unit is installed on the desk or the like, leave at
least 4 cm of space in the left and right sides. Leaving
40 cm or more of space above the unit is recommended for
service operation.