Motorola WiNG 5.5 Reference Manual page 778

13 - 40 WiNG 5.5 Access Point System Reference Guide
Bound
Metric
Interface Bias
Neighbor Bias
Root Bias
The Multicast Path
Mesh Point Name
Subscriber Name
Subscriber MPID
Group Address
Path Timeout
The Neighbors
Mesh Point Name
Destination Addr
Neighbor MP ID
Neighbor IFID
Root MP ID
Is Root
Mobility
Radio Interface
Indicates whether the root is bound or unbound.
Displays the computed path metric between the neighbor and their root mesh point.
This field lists any bias applied because of preferred root Interface Index.
This field lists any bias applied because of preferred root next-hop Neighbor IFID.
This field lists any bias applied because of preferred root MPID.
tab displays the following:
Displays the name of each configured mesh point in the RF Domain.
Lists the subscriber name is used to distinguish between other mesh point neighbors both
on the same device and on other devices.
Lists the subscriber ID to distinguish between other mesh point neighbors both on the
same device and on other devices.
Displays the MAC address used for the group in the mesh point.
The timeout interval in seconds. The interpretation this value will vary depending on the
value of the state. If the state is Init or In Progress, the timeout duration has no
significance. If the state is Enabled, the timeout duration indicates the amount of time left
before the security validity check is initiated. If the state is Failed, the timeout duration is
the amount of time after which the system will retry.
tab displays the following:
Displays the name of each configured mesh point in the RF Domain.
The destination is the endpoint of mesh path. It may be a MAC address or a mesh point ID.
The MAC Address that the device uses to define the mesh point in the device that the
neighbor is a part of. It is used to distinguish the device that is the neighbor.
The MAC Address used by the interface on the neighbor device to communicate with this
device. This may define a particular radio or Ethernet port that communicates with this
device over the mesh.
The mesh point ID of the neighbor's root mesh point.
A root mesh point is defined as a mesh point that is connected to the WAN and provides
a wired backhaul to the network. Yes if the mesh point that is the neighbor is a root mesh
point or No if the mesh point that is the neighbor is not a root mesh point.
Displays whether the mesh point is a mobile or static node. Displays True when the device
is mobile and False when the device is not mobile.
This indicates the interface that is used by the device to communicate with this neighbor.
The values are 2.4 and 5.0, indicating the frequency of the radio that is used to
communicate with the neighbor.