Motorola WiNG 5.5 Reference Manual page 303

Admin Status
7. To edit the configuration of an existing port channel, select it from amongst those displayed and select the
Port Channel Basic Configuration
Figure 5-136 Device Overrides - Port Channels - Basic Configuration tab
8. Set the following port channel Properties:
Description
Admin Status
Speed
A green check mark defines the listed port channel as active and currently enabled with
the access point's profile. A red "X" defines the port channel as currently disabled and not
available for use. The interface status can be modified with the port channel configuration
as required
screen displays by default.
Enter a brief description for the port channel (64 characters maximum). The description
should reflect the port channel's intended function.
Select the Enabled radio button to define this port channel as active to the profile it
supports. Select the Disabled radio button to disable this port channel configuration
within the profile. It can be activated at any future time when needed. The default setting
is disabled.
Select the speed at which the port channel can receive and transmit the data. Select
either 10 Mbps, 100 Mbps, 1000 Mbps. Select either of these options to establish a 10,
100 or 1000 Mbps data transfer rate for the selected half duplex or full duplex
transmission over the port. These options are not available if Auto is selected. Select
Automatic to enable the port channel to automatically exchange information about data
transmission speed and duplex capabilities. Auto negotiation is helpful when in an
environment where different devices are connected and disconnected on a regular basis.
Automatic is the default setting.
Device Configuration 5 - 217
Edit button. The