Motorola WiNG 5.5 Reference Manual page 167

VRRP State Check
6. Set the following OSPF Overload Protection
Number of Routes
Retry Count
Retry Time Out
Reset Time
7. Set the following Default
Originate
Always
Metric Type
Route Metric
8. Refer to the Route Redistribution
Select the + Add Row button to populate the table. Set the
include connected, kernel and static.
Select the Metric Type
Metric option to define route metric used with the redistributed route.
9. Use the OSPF Network
Select the + Add Row button to populate the table. Add the IP address and mask of the
Additionally, define the OSPF area (IP address) to which the network belongs.
10. Set an OSPF Default Route Priority
11. Select the Area Settings
An OSPF Area contains a set of routers exchanging Link State Advertisements (LSAs) with others in the same area. Areas
limit LSAs and encourage aggregate routes.
Select this option to enable checking VRRP state. If the interface's VRRP state is not
Backup, then the interface is published via OSPF.
settings:
Use the spinner controller to set the maximum number of OSPN routes permitted. The
available range is from 1 - 4,294,967,295.
Set the maximum number of retries (OSPF resets) permitted before the OSPF process is
shut down. The available range is from 1 - 32. The default setting is 5.
Set the duration (in seconds) the OSPF process remains off before initiating its next
retry. The available range is from 1 - 3,600 seconds. The default is 60 seconds.
Set the reset time (in seconds) that, when exceeded, changes the retry count is zero.
The available range is from 1 - 86,400. The default is 360 seconds.
Information:
Select this option to make the default route a distributed route. This setting is disabled
by default.
Enabling this settings continuously maintains a default route, even when no routes
appear in the routing table. This setting is disabled by default.
Select this option to define the exterior metric type (1 or 2) used with the default route.
Select this option to define route metric used with the default route. OSPF uses path
cost as its routing metric. It's defined by the speed (bandwidth) of the interface
supporting a given route.
table to set the types of routes that can be used by OSPF.
option to define the exterior metric type (1 or 2) used with the route redistribution. Select the
table to define networks (IP addresses) to connect using dynamic routes.
(1 - 8,000) as the priority of the default route learnt from OSPF.
tab.
Device Configuration 5 - 81
Route Type used to define the redistributed route. Options
Network(s) participating in OSPF.