Yamaha A4000 Owner's Manual page 261

23: WAH + DIST + DELAY, 24: WAH + OVERDRIVE + DELAY
1 Wah Sensitive 0 — 127
2 Wah Cutoff Freq Ofst 0 — 127
3 Wah Resonance 1 — 12.0
4 Wah Release 10ms — 680ms
5 Dist Drive 0 — 127
6 Dist Output Level 0 — 127
7 Dist EQ Low Gain -12dB — +12dB
8 Dist EQ Mid Gain -12dB — +12dB
9 Delay Mix 0 — 127
10 Delay Time 0.1ms — 1480.0ms
11 Dly Feedback Level -63 — +63
12 Dry/Wet Balance D63>W — D=W — D<W63
25: TALKING MODULATOR
1 Vowel a/i/u/e/o
2 Move Speed 1 — 62
3 Drive 0 — 127
4 Output Level 0 — 127
26: 3BAND EQ
1 EQ Low Frequency 50Hz — 2.0kHz
2 EQ Low Gain -12dB — +12dB
3 EQ Mid Frequency 100Hz — 10.0kHz
4 EQ Mid Gain -12dB — +12dB
5 EQ Mid Width 1 — 12.0
6 EQ High Frequency 500Hz — 16.0kHz
7 EQ High Gain -12dB — +12dB
8 Input Mode mono/stereo
27: ISOLATOR
1 On/Off SW off, on
2 Low Level 0 — 127
3 Mid Level 0 — 127
4 High Level 0 — 127
5 Low Mute SW off, on
6 Mid Mute SW off, on
7 High Mute SW off, on
28: HARMONIC ENHANCER
1 HPF Cutoff Freq 500Hz — 16.0kHz
2 Drive 0 — 127
3 Mix Level 0 — 127
29: VOICE CANCEL
1 Low Adjust 0 — 26
2 High Adjust 0 — 26
30: COMPRESSOR
1 Threshold -48dB — -6dB
2 Attack 1ms — 40ms
3 Release 10ms — 680ms
4 Ratio 1 — 20.0
5 Output Level 0 — 127
31: COMP + DIST
1 Drive 0 — 127
2 LPF Cutoff Freq 1.0kHz — 18.0kHz, thru
3 Output Level 0 — 127
4 Edge 0 — 127
5 Attack 1ms — 40ms
6 Release 10ms — 680ms
7 Threshold -48dB — -6dB
8 Ratio 1 — 20.0
9 EQ Low Frequency 32Hz — 2.0kHz
10 EQ Low Gain -12dB — +12dB
11 EQ Mid Frequency 100Hz — 10.0kHz
12 EQ Mid Gain -12dB — +12dB
13 EQ Mid Width 1 — 12.0
14 Dry/Wet Balance D63>W — D=W — D<W63
32: COMP + DIST + DELAY, 33: COMP + OVERDRIVE + DELAY
1 Comp Threshold -48dB — -6dB
2 Comp Ratio 1 — 20.0
3 Comp Attack 1ms — 40ms
4 Comp Release 10ms — 680ms
5 Dist. Drive 0 — 127
6 Dist Output Level 0 — 127
7 Dist EQ Low Gain -12dB — +12dB
8 Dist EQ Mid Gain -12dB — +12dB
9 Delay Mix 0 — 127
10 Delay Time 0.1ms — 1480.0ms
11 Dly Feedback Level -63 — +63
12 Dry/Wet Balance D63>W — D=W — D<W63
Sets the wow filter sensitivity to input variation
Offsets the wow filter control frequency
Sets the wah filter bandwidth
Sets the time before the wow filter center frequency returns to normal
Degree of distortion
Output level
Amount of gain by which the EQ will boost/cut the low range
Amount of gain by which the EQ will boost/cut the mid range
Delay level
Delay time
Amount of feedback
Balance of the dry sound and effect sound
Vowel select
The amount of time it takes to change to the selected vowel
The amount of enhancement applied
Output level
Frequency at which the EQ will boost/cut the low range
Amount of gain by which the EQ will boost/cut the low range
Frequency at which the EQ will boost/cut the low range
Amount of gain by which the EQ will boost/cut the mid range
Width of the area in which the EQ will boost/cut the mid range
Frequency at which the EQ will boost/cut the high range
Amount of gain by which the EQ will boost/cut the high range
Mono/stereo input mode selection
Isolator switch
Low frequency level
Mid frequency level
High frequency level
Low frequency mute switch
Mid frequency mute switch
High frequency mute switch
Frequency at which the high pass filter will cut the low range of the effect sound
Degree with which the enhancer effect will be applied
Level at which the effect sound will be mixed into the dry sound
Adjusts the lower frequency of the midrange cancellation
Adjusts the upper frequency of the midrange cancellation
Input level at which compression begins to be applied
Time until when the compressor begins to take effect
Time until the compressor effect disappears
Compression ratio of the compressor
Output level
Degree of distortion
Frequency at which the filter will cut the high range
Output level
Curve of distortion characteristics (127: distortion begins suddenly; 0: distortion begins gradually)
(Compressor) Time until when the compressor begins to take effect
(Compressor) Time until the compressor effect disappears
(Compressor) Input level at which compression begins to be applied
(Compression) Compression ratio of the compressor
Frequency at which the EQ will boost/cut the low range
Gain with which the EQ will boost/cut the low range
Frequency at which the EQ will boost/cut the mid range
Gain with which the EQ will boost/cut the mid range
Width of the mid range area which the EQ will boost/cut
Balance of the dry sound and effect sound
Input level at which compression begins to be applied
Compression ratio of the compressor
Time until when the compressor begins to take effect
Time until the compressor effect disappears
Degree of distortion
Output level
Gain with which the EQ will boost/cut the low range
Gain with which the EQ will boost/cut the mid range
Delay level
Delay time
Amount of feedback
Balance of the dry sound and effect sound
Effect Parameter List
261
Appendix
A5000/A4000 •