Toshiba Perfecptione Installation And Maintenance Manual page 268

PROGRAMMINGPROCEDURES
SECTION 200-255-319
FEBRUARY1992
, 1,.
,
0
0
STS TLK will be printed in response to a
q
entered following the above dialing prompt.
The
q
released the trunk under test (B),
therefore the output indicates the status of
the monitor link (A). The program will auto-
matically return to the TRK prompt in order to
allow another trunk to be selected.
STS DDL will be printed if a
q
was entered
before dialing was complete. This state is the
same as DDL above,
STS RLSA will be printed if the monitor link
(A) is released due to a malfunction or some
outside influence. The trunk under test (B)
will also be released and the program will
automatically return to the REQ prompt .
STS RLSB will be printed if the trunk under
test (Trunk B) is released due to a malfunc-
tion or some outside influence. The program
will automatically return to the TRK prompt in
order to allow another trunk to be selected.
Example: Monitor link trunk (A) = T014.
Test center DN = 730-5000.
Test DN = 730-0002.
Trunk under test (B) = T012.
I
PROMPT 1 USER ENTRY 1
. ..or...
TABLE19-5
Procedure - Peripheral Equipment Diagnostic Procedure
Authorization Procedure must be completed. If an OK response is received, proceed as follows:
ITEM PROMPT
USER ENTRY NOTE
OK TPER
- DISK LOADING -
=Q
I 1
NOTE:
(con timed)
See Table 19-5a forpossible entries. The REQ prompt will repeat following each test. Enter as many
separate entries as required.
19-11