Table of Contents
Advertisement
PROGRAMMING PROCEDURES
SECTION 200-255-307
FEBRUARY 1992
CHAPTER 7
Al-i-ENDANT/STATION/DSS DATA
1. Attendant
Data Block (Table
7-I)
1.01 The Attendant
Data Block (DAlT
Program)
defines one or two attendant
consoles
in the sys-
tem and selects
the attendant
options.
Data
is
entered
as follows:
REQ (Request)-Indicates
that the program
has
loaded.
Three responses
are possible:
NEW-To
create a new Data Block.
CHG-To
alter an existing Data Block.
OUT-To
delete an existing
Data Block.
AN0
(Attendant
Number)---Selects
the console
that is to be assigned.
Enter: 0 or 1.
POR (Port Number)-Selects
the port that is to be
occupied
by the console.
Enter: For PERCEPTlONe-LO01
for Atten-
dant Console
#O.
L151 for Attendant
Console
#I.
For PERCEPTION,,-LO01
for Atten-
dant Console
#O.
LO1 1 for Attendant
Console
#l.
NLPK
(Number
of Loop
Keys)-Indicates
the
quantity
of buttons
that can be designated
as
Attendant
Loop Buttons.
_
Enter: 4, 6, or 8.
NOTE:
If the system is operating in the Lodging/
Health Care mode, only four loop buttons can
be assigned.
LKO (Lockout
Allowed?)-A
"Y" response
will
enable the lockout feature,
and will not allow the
attendant
to re-enter
a held m
button confer-
ence.
Enter: Y or N.
paging zones, or the Expanded
Internal Paging
Group
and all external
paging
zones. Options
that are not assigned
to the feature
access
button may still be accessed
by dialing a paging
access code.
Enter one of the following:
INT-Expanded
Internal
Group
Paging
(Group 0).
EXT-External
All Paging (Zones 0 - 4).
N-External
Paging to Zone N (0 - 4).
ALL-Expanded
Internal Group Paging and
External All Paging.
NONE-No
Internal
or External
Paging
Access.
PRI (Incoming
Call Priority )-A
"Y" response
will
direct all calls to the attendant
console according
to the priority defined by the PRl - PR5 prompts.
An "N" response
will direct all calls to the atten-
dant console
on a first-in/first-out
priority basis.
Enter: Y or N.
PRl - 5 (Priority
1 - 5, Current)--A
"Y" response
to the PRI prompt
will print the current
priority
tables.
PRl - 5 (Priority
1 - 5, Set)--Defines
the incoming
call priority. The possible types of calls are: CO,
FX, TIE, WAT, OPR, RCL, HLD, TIM, LNl, LN2,
INT, SER (Business
mode only).
Enter: NN or NNN (type of call).
NOTE:
There is no program provided to print out the
Attendant Data Bock.
PAG (Page Button)-Assigns
the console m
button
to access
either the Expanded
Internal
Paging
Group
(Group
0), one or all external
7-1
Advertisement
Chapters
Table of Contents
