Modem Pooling Data Block (Table 1 - Toshiba Perfecptione Installation And Maintenance Manual

PROGRAMMINGPROCEDURES
SECTION 200-255-311
FEBRUARY1992
3. Modem Pooling Data Block (Table 11-3)
3.01 The Modem Pooling Data Block (DMDM
Program) identifies the Modem Pooling ports. The
Modem Pooling Data Block is not used with the
PDIU-DS. See the DDIU Data Block and the In-
stallation Instructions section for Modem Pooling
using the PDIU-DS.
REQ (Request)-Indicates that the program has
loaded. Two responses are possible:
NEW-To assign a new Data Block.
OUT-To delete an existing Data Block.
POR (Port Number)--Identifies the hardware lo-
cation of the NMDU circuits that are to be de-
fined. The port number has two parts:
1) NMDU PCB location:
PERCEPTION,-L00-L11/L15-L26(NN).
PERCEPTION,,-LOO - L31.
2) Circuit number on that PCB: 1 - 4 (X).
3) When a circuit number is identified, two
circuits are assigned, one for a modem and
one for its associated DDIU (i.e., if circuit 1
is identified, circuits 1 and 5 are assigned;
if circuit 2 is identified, circuits 2 and 6 are
assigned, and so on).
Enter: Port number (LNNX).
NOTE:
Port L314 cannot be assigned.
11-7