Toshiba Perfecptione Installation And Maintenance Manual page 159

PROGRAMMING PROCEDURES
SECTION 200-255-307
FEBRUARY 1992
TABLE 7-2 (continued)
Error Codes
Error Code 1
Program Name: Electronic Telephone Data Block (DEKT)
Meaning
1 EREKT 20 1 The SDC has already been assigned to this Speed Dial.
-1
1 EREKT 21 1 The input port is not an NEKUINDKU port (SIG LNNX).
EREKT 22 PVR NNN/PVN NNN is entered, but trunk DN NNN has not been assigned.
EREKT 23 The input DN is a trunk DN (VCP NNN Hunt DN).
EREKT 24 32 DNs have already been assigned to the Distributed Hunt Group.
I-EREKT 26 TThe input port conflicts with the electronic/digital telephone's port (KEY x DIU LNNX).
I
1 EREKT27 1
The station is assigned as a Lodging/Health Care guest room telephone, therefore only fixed
m buttons can be assigned.
EREKT 28 Autodial (ADL) digits exceed the maximum of 16.
I
1 EREKT 30 1 The input port is not an NDCU/NDKU open port (KEY x DIU LNNX).
1 EREKT 31 (The m button has already been assigned to another button.
I
I EREKT 32 1 The associated DIU is busy.
-1
EREKT 33 MES is set but the station is not DIS = 2.
EREKT 34 DIS was entered, but DIS does not equal 1.
EREKT 40 The m button has already been assigned in the system once.
EREKT 41 More than two digits were entered as station HNG XX.
EREKT 42 The Paging Group number is out of range. It should be 0 or 2 - 17.
EREKT 43
The group to be assigned is already full (maximum member number of each Group 2 - 17 is 32;
I
maximum member number of Group 0 is 96).
EREKT 44 The same Group number was entered twice.
I
I EREKT 45 1 More than 4 (maximum) Paging Groups have been entered.
---1
I
EREKT 47
The electronic/digital telephone's assigned DSS console must be
can be deleted.
EREKT 48
The m button cannot be set because the station is not an attendant-position electronic/digital
telephone (DSD2 Data Block).
EREKT 49 The port has already been assigned to a trunk.
EREKT 50
I
The entry should be AIT (0 and/or 1 is not required).
EREKT 51 The m button or m button has already been assigned to another button/station.
I
EREKT 52 1 The Agent Line number conflicts with an existino line-number.
I
EREKT 53 The input DN is not a Supervisor DN.
EREKT 54 No NOCU is equipped at that location.
EREKT 55 A PCB other than an NEKWNDKU has been assigned to the slot.
EREKT 56 The input port has already been assigned.
EREKT 57 The input data is different from the old data.
EREKT 58 The
port
has already been assigned to an OCA port.
I EREKT 59 1 An ACD Supervisor DN is not allowed to hunt to another DN.
7-12