Toshiba Perfecptione Installation And Maintenance Manual page 183

PROGRAMMINGPROCEDURES
SECTION 200-255-309
FEBRUARY1992
TOL (Toll Restriction Class)-Assigns one of the
IO classes of Toil Restriction to each outgoing
TIE, CCSA, and DID trunk. Classes 0 - 7 are
defined in the Toll Restriction Data Block (DTOL
Program). Class 8 is simple Toll Restriction and
restricts when either 1 or n is dialed as the first
digit. NONE defines the trunk as unrestricted.
Enter: 0 - 8 or NONE.
FLT (Flash-hook Timing)-Defines the length of
time of a flash-hook (line open) while connected
to a CO trunk. On an electronic/digital telephone,
the flash-hook will occur whenever them key
is pressed.
Enter: 1 = 500 milliseconds.
2 = 1 second.
CTX (Centrex)-A "Y" response indicates that the
trunk group is operating on Centrex lines. An "N"
response indicates that the trunk group is not
operating on Centrex lines. The entry "Y" made
here defeats Toll Restriction.
Enter: Y or N.
NOTE:
When DNIS = Y, the following prompts do
NOT apply, eventhough they appear on the
screen: COS, IAB, TRNI, TRN2, and TOL.
2. Print Trunk Group Data Block (Table 9-2)
2.01 To use the Print Trunk Group Data Block
(PTGP Program):
l
Perform the Authorization Procedure (Level 1 or
Enter: PTGP (in response to the OK prompt).
l
When an REQ prompt is received after the
program is loaded:
Enter one of the following commands:
ALL-All Trunk Group Data Blocks will be output.
GRPXX-Trunk Group XX Data Block will be out-
put.
COT-All CO Trunk Group Data Blocks will be
output.
FEX-All FX Trunk Group Data Blocks will be
output.
WAT-All WATS Trunk Group Data Blocks will be
output.
TIE-All TIE Trunk Group Data Blocks will be
output.
DID-All DID Trunk Group Data Blocks will be
output.
CSA-All CCSA Trunk Group Data Blocks will be
output.
PVL-All Private Line Trunk Group Data Blocks will
be output.
NOTE:
The output format willbe the same as the input
format that is used in the DTGP Program.
l
REQ will be prompted when the printout is
complete.
Enter: m m
q
(to exit the program).
9-3