Table of Contents
Advertisement
CHAPTER
15
TRAFFIC
MEASUREMENT
DATA
1. Traffic
Measurement
Data Block (Table 15-1)
1 .Ol The Traffic Measurement
Data Block (DTRF
Program)
defines
the parameters
that control the
Traffic Measurement
feature.
Data is entered
as
follows:
REQ (Request)-Indicates
that the program
has
loaded.
Four responses
are possible:
STT (Start
Command)-Starts
the
record-
keeping
and reporting
activity when
SCH =
CMD. (STT must be entered
after each RPT
request.)
RPT (Report Command)-A
report will follow if
record-keeping
has been started with the SIT
command
(see Table 15-1 a for report format).
OUT (Out Command)-Deletes
record-keep-
ing and reports.
CHG (Change
Command)-Establishes
or al-
ters the reporting
parameters.
The next prompt
for CHG input will be:
SYST. DATE MMDDYY
(System
Date)-Reports
the date that is currently
in memory
and gives an
opportunity
for a change.
Enter: New date: MMDDYY
or
q
(no change).
DOW (Day of Week)--Identifies
the current day of
the week for the system clock.
Enter: SUN, MON, TUE, WED,THU,
FRI, SAT,
or
q
(no change).
SYST. TIME HHMMSS
(System
Time)--Reports
the time that is currently
in memory
and gives an
opportunity
for a change.
Enter: New time: HHMMSS
(24-hour
clock) or
q
(no change).
'
'
PROGRAMMING PROCEDURES
SECTION 200-255-315
FEBRUARY 1992
RPT command
is given in response
to
REQ above.
30-Report
will occur every 30 minutes,
beginning
at the time listed as STR (next
prompt).
60-Same
as above,
but at 60-minute
intervals.
NOTE:
Reports
will continually
be output at the speci-
fied time intervals
unless
77Y is disabled
(OFF). Record-keeping
will continue,
but only
the last time interval
will be saved
and re-
ported
when the TTY is enabled.
STFLDATE
MMDDYY
(Start
Date)-Defines
the
start date for record-keeping
and reporting,
out-
puts current data, and gives an opportunity
for a
change.
Enter: Start Date: MMDDYY
or
q
(no change).
STR.TIME
HHMM (Start Time)-Defines
the start
time for record-keeping
and reporting,
outputs
current
data,
and gives an opportunity
for a
change.
Enter: Start Time: HHMM or
q
(no change).
RPT (Report
Parameters):
SYST
(System
Data)
ATT0
(Attendant
0)
A-l-T1
(Attendant
1)
TGPOO
(Trunk Group 00)
TGPI 5
(Trunk Group
15)
Selects
those
parameters
that are to be re-
corded (see Table 15lb).
The current data (Y or
N) is output for each parameter
and an opportu-
nity is given for a change.
Enter: Y or N (followed
by a
q
for each pa-
rameter).
SCHXXX
(Schedule
of Reports)-Defines
the
schedule
for reports;
outputs
the current
data;
and gives an opportunity
for a change.
Enter: CMD-Report
will occur only when the
15-1
Advertisement
Chapters
Table of Contents
