Toshiba Perfecptione Installation And Maintenance Manual page 184

PROGRAMMING PROCEDURES
SECTION 200-255-309
FEBRUARY 1992
TABLE 9-l
Procedure - Trunk Group Data Block
Authorization Procedure must be completed. If an OK response is received, proceed as follows:
NOTES:
(continued)
I. A maximum of 7 6 Trunk'Groups (normally 00 - 75) is possible. If priva te lines are to be equipped, the code
PVL is used in place of 15.
2. TKT cannot be changed. The Data Block must be removed (OUT) and NEW data must be entered. The
"DNIS" prompt will appear only when one of these trunk types (DID, CCSA, TIE) is entered.
3. This prompt will appear only when TKT is DID, CCSA, or TIE.
4. This prompt will appear only when DNIS is allowed.
5. The Trunk Group that is to be stepped to if this group is busy (00 - 15).
6. COS is meaningful only for TiE/CCSA/DiD Trunks. Sixteen COS groups are provided and are defined in the
Class of Service Data Block.
7. List the digits which are to be ignored for the purpose of Toil Restriction, These,digits will be outpulsed, but
not counted as the first digit.
8. Enter the number of digits which are to be stripped from an incoming dialed DN (TIE, DID, or CCSA Trunk).
Example: IAB = 1. incoming DN = 8249. Recognized DN = 249.
9. Enter the absorbed digit (IAB) to be translated.
X = the absorbed digit (IAB) to be translated. Y or YY = the translated digits to be inserted.
Example: IAB = 1. TRNl = 9#2.
incoming DN = 949. Recognized DN = 249.
TRN2 = 8#3. incoming DN = 849.
Recognized DN = 349.
10. Classes 0 - 7are defined in the Toil Restriction Data Block
(DTOL
Program).
Class 8 = 0 and 1 restriction. NONE = no restriction.
11. 1 = 500 ms. 2 = 1 second.
12. Enter yes if the trunk group is
73. mm = ignore line entered.
=B = Backspace.
Stop printing and return to REQ.