Motorola KEY 3000 User Manual page 38

KVL 3000 User's Guide
Perform Initial
Programming
3-2
Introduction
Before using your KVL 3000 to enter and load
encryption keys, several parameters that determine
how the KVL 3000 operates must be programmed.
The parameters are divided into two categories:
D User Preference
D System Dependent
Instructions for programming these parameters
begin on the next page.
Note Many of the parameters described in this
chapter are also accessible from the CONFIG
menu in ASTRO 25 operating mode. Making
changes to one of these common parameters
from either ASN or ASTRO 25 operating mode
affects the setting for both modes. For example,
if you are in ASN mode and change the
Power Down Timeout setting (TIMEO) to 60
seconds, the timeout will also be 60 seconds
when in ASTRO 25 operating mode.
The common parameters are as follows:
D PASSWD (setting
Operator passwords)
D DATE (setting month, day, year)
D TIME (setting hours, minutes, seconds)
D SHARE (on or off)
D SOUND (on or off)
D TIMEO (setting
seconds)
D BAUDR (selects baud rate for RS232
communications)
D FIPS (on or off)
D SYSKEY (allows System Key to be
entered; for DVI XL algorithms only)
D DIAL (setting Tone or Pulse dialing)
Supervisor and
timeout period in
ASN Operation