Motorola KEY 3000 User Manual page 132

KVL 3000 User's Guide
Error/Status
Message
Probable Cause(s):
NO
RESPONSE
Remedy(s):
FROM TARGET
Probable Cause(s):
NOT A
VALID VALUE
Remedy(s):
Probable Cause(s):
NOT ALLOWED
KMC MODE
Remedy(s):
ACTIVE
Probable Cause(s):
NOT IN
Remedy(s):
SUPERVISOR
MODE
Probable Cause(s):
NOT A
VALID KEY
Remedy(s):
Probable Cause(s):
NO USK
Remedy(s):
Probable Cause(s):
OFFSET
OUT OF RANGE
Remedy(s):
8-6
Probable Cause and Remedy
1) Faulty Keyload Cable or con
nection
2) Target device is turned off
3) Target device is incompatible
with KVL 3000
1) Ensure proper keyload cable
connections at each end; try known
good keyload cable
2) Turn target unit power on
3) Make sure target device is com
patible with KVL 3000
1) Entry is out of acceptable range
1) Refer to manual and re enter
1) Attempt to delete the log was
made while KVL 3000 has KMC
mode turned on
1) Navigate to KMC in CONFIG
menu and turn KMC USAGE Off;
you may now delete the log
1) Not in Supervisor mode
1) Power cycle KVL 3000, then en
ter Supervisor password when
prompted for password
1) The key entered is not valid ac
cording to the algorithm selected.
1) Re enter key or check with your
Security Officer.
1) Unique Shadow Key (USK) has
not been entered into (or has been
erased from) the KVL 3000
1) Enter USK (typically assigned
by Crypto/Security Officer) for each
algorithm supported by the
KVL 3000
1) While entering an offset value
for a Group Map, the value entered
exceeds the acceptable range
1) Enter an offset value within
range (0 thru 63)
ASN Operation